Improvement to Cross Bolt Die Lock Rings. A socket cap screw is now used to lock the ring in place. The improvement allows you to make fine adjustments without "pushing" on the ring as you are snugging it up. Fits any standard 7/8" x 14 dies. Forster Products has solved two problems common to many reloaders: misaligned die locking rings and damaged die threads. Either of those situations can...
Curved Linkage accessory for the Co-Ax® Reloading Press allows for increased access to the shell holder jaws. This will help get cases in/out of the shell holder jaws faster and make it easier to replace the jaws if necessary.
@page {margin: 96px 96px 96px 96px;}.docbody {font-family: 'Times New Roman'}p.MsoNormal, li.MsoNormal, ul.MsoNormal, div.MsoNormal{ margin-top:0px; margin-right:0px; margin-bottom: 1.0pt; margin-left:0cm;line-height:1.07; font-size:11.0pt; white-space: pre-wrap}Clamps around the entire die, resulting in a more precise mating of the lock ring threads to the die threads. They are supplied with all...
Spare/replacement Decapping Pin fits Full Length, Bushing Bump and Neck Sizing Dies. Select Short (0.75″) or Long (1″) Select Standard or “Special” (0.054″ dia.) The Special pins are smaller in diameter for decapping brass with small flash holes.
Spare/replacement Decapping Pin fits Full Length, Bushing Bump and Neck Sizing Dies. Select Short (0.75″) or Long (1″) Select Standard or “Special” (0.054″ dia.) The Special pins are smaller in diameter for decapping brass with small fllash holes.
Spare/replacement Decapping Pin fits Full Length, Bushing Bump and Neck Sizing Dies. Select Short (0.75″) or Long (1″) Select Standard or “Special” (0.054″ dia.) The Special pins are smaller in diameter for decapping brass with small flash holes.
Spare/replacement Decapping Pin fits Full Length, Bushing Bump and Neck Sizing Dies. Select Short (0.75″) or Long (1″) Select Standard or “Special” (0.054″ dia.) The Special pins are smaller in diameter for decapping brass with small flash holes.
The Shell Holder Jaw Wear Plate protects the Co-Ax Press casting from wear as the Shell Holder Jaws grasp the cases. Complete installation instructions for this replacement part — and the complete Shell Holder subassembly — are provided in section 6 of the Co-Ax Reloading Press Instructions.
![Forster - Die Lock Ring 1-1/14\"](images/atrex/fo_die-g-30.jpg "Forster - Die Lock Ring 1-1/14\\"")
