21st Century - Caliber Specific Expander Mandrel - .203", sold individually Our caliber specific expander mandrels are available in.0005” increments in calibers 22 to 338 and will range from .001” above bulletdiameter to at least .003” below bullet diameter depending on caliber.  This will allow the reloader to find properneck tension to fine-tune their loads.  The...

Neck-Up Mandrel .22 to 6mm 

Neck-Up Mandrel 6mm to 6.5 mm 

The Accu-Ring is a sizing/seater die lock-ring whichprovides reference marks in increments of thousandths of an inch (0.001”). Sizing die (primary use) – Designed mainly for sizing dies,the Accu-Ring helps you zero in on what you want the headspace length of yourcases to be.Seater die (secondary use) – The Accu-Ring also allows youto make fine adjustments to bullet seating...

Curved Linkage accessory for the Co-Ax® Reloading Press allows for increased access to the shell holder jaws. This will help get cases in/out of the shell holder jaws faster and make it easier to replace the jaws if necessary.  

@page {margin: 96px 96px 96px 96px;}.docbody {font-family: 'Times New Roman'}p.MsoNormal, li.MsoNormal, ul.MsoNormal, div.MsoNormal{ margin-top:0px; margin-right:0px; margin-bottom: 1.0pt; margin-left:0cm;line-height:1.07; font-size:11.0pt; white-space: pre-wrap}Clamps around the entire die, resulting in a more precise mating of the lock ring threads to the die threads. They are supplied with all...

Spare/replacement Decapping Pin fits Full Length, Bushing Bump and Neck Sizing Dies. Select Short (0.75″) or Long (1″) Select Standard or “Special” (0.054″ dia.) The Special pins are smaller in diameter for decapping brass with small flash holes.

Spare/replacement Decapping Pin fits Full Length, Bushing Bump and Neck Sizing Dies. Select Short (0.75″) or Long (1″) Select Standard or “Special” (0.054″ dia.) The Special pins are smaller in diameter for decapping brass with small fllash holes.

Spare/replacement Decapping Pin fits Full Length, Bushing Bump and Neck Sizing Dies. Select Short (0.75″) or Long (1″) Select Standard or “Special” (0.054″ dia.) The Special pins are smaller in diameter for decapping brass with small flash holes.

The Shell Holder Jaw Wear Plate protects the  Co-Ax Press  casting from wear as the  Shell Holder Jaws  grasp the cases. Complete installation instructions for this replacement part — and the complete Shell Holder subassembly — are provided in section 6 of the  Co-Ax Reloading Press Instructions.  

.30 Cal Seater Stem for Berger 215gr Hybrid 1.1"

308 Seater Stem for 155 Scenar Lapua 1"

6.5mm Seater Stem Long for 140gr Berger Hybrid 1.6"

6.5mm Seater Stem Long  for Hornady 143 ELD-X