21st Century - Caliber Specific Expander Mandrel - .203", sold individually Our caliber specific expander mandrels are available in.0005†increments in calibers 22 to 338 and will range from .001†above bulletdiameter to at least .003†below bullet diameter depending on caliber. This will allow the reloader to find properneck tension to fine-tune their loads. The...
Curved Linkage accessory for the Co-Ax® Reloading Press allows for increased access to the shell holder jaws. This will help get cases in/out of the shell holder jaws faster and make it easier to replace the jaws if necessary.
Spare/replacement Decapping Pin fits Full Length, Bushing Bump and Neck Sizing Dies. Select Short (0.75″) or Long (1″) Select Standard or “Special” (0.054″ dia.) The Special pins are smaller in diameter for decapping brass with small flash holes.
Spare/replacement Decapping Pin fits Full Length, Bushing Bump and Neck Sizing Dies. Select Short (0.75″) or Long (1″) Select Standard or “Special” (0.054″ dia.) The Special pins are smaller in diameter for decapping brass with small flash holes.
Spare/replacement Decapping Pin fits Full Length, Bushing Bump and Neck Sizing Dies. Select Short (0.75″) or Long (1″) Select Standard or “Special” (0.054″ dia.) The Special pins are smaller in diameter for decapping brass with small flash holes.
The Shell Holder Jaw Wear Plate protects the Co-Ax Press casting from wear as the Shell Holder Jaws grasp the cases. Complete installation instructions for this replacement part — and the complete Shell Holder subassembly — are provided in section 6 of the Co-Ax Reloading Press Instructions.
![1-1/14\" Die Lock Ring](images/no_picture.gif "1-1/14\\" Die Lock Ring")
![21st Century - Caliber Specific Expander Mandrel - .203\"](images/atrex/tfc_e203.jpg "21st Century - Caliber Specific Expander Mandrel - .203\\"")
